Went down the shed and made a slide hammer, took about 5 minutes.

Another 5 minutes and I had pulled the dented filler neck back up.

Inside this tank is like new with no rust or loose baffles.

Then I started looking at the rear shock, the new XT one is slightly different where the circlip holds the spring retainer, will have to do a few measurements as the XT has a adjuster rod up the centre of the shaft.

One fork leg has a bit of surface rust up above the triple clamps so I might see if the other forks that came with the bike and are Showa's are interchangeable.

Other forks.

Regards Eric