I used to put a heat gun over white creases, even a hair dryer or hot water will lessen the whiteness.NordieBoy wrote:He's a new one. Well he's been riding a snowboard, blutac'd to my monitor for a few years now.
I'll have to measure it up.
Once I'd picked the height and top width then it was a matter of doing the 2nd set of triangles to get the angle correct and the outside bits to go flush with the existing bits.
It rides well too. No shaking, gets pressed back slightly into the GPS and the wind hits about top of shoulders.
About as effective as my Givi on the DR for quite a bit more $$.
The Givi was free, this one cost me a $24 rubbish bin. Took the template up town and searched until I found a bin with the right colour and shape.
Not sure how a coloured screen would go as they'd whiten up on the creases.
Might not get rid of it completely but will reduce it.
Any coloured plastics with white crease marks can be improved with a bit of heat.
), made it fit snugly over the bolt flats, and kept filing a groove until I could just fit the split pin in. Lots of Yamalube and we'll see how it goes.
