After buying a small repair on the original carrier XT600E (It is very difficult to get this piece)
So I tried to design this piece from sheet metal.
The entire carrier sheet is from 5 mm, mounting clips of 2 mm and a top supporting rods are 6 mm round timber.

Realization of the final product should be as soon as possible.

ORIGINAL:


MY DESIGN:


FINAL RENDERING:
LQ

HQ

Have you made these and how sturdy are they? Do they fit the 90-94 3TB model?

AndyYam wrote:Have you made these and how sturdy are they? Do they fit the 90-94 3TB model?

For the production going in 2017 one piece.
I check and mount on the motorcycle XT600E 1998 - hopefully it will be the same

I think however that I buy tube bender...