As in title can I use the forks and front wheel on My 660 frame or will I need the yokes aswell. Thanx In advance

Yes you can

Mine had a 750 front end on it when I bought it, not sure if it's using the 660 or 750 yolks though

Rick

Probably using the 750 yokes, but the original stem swapped over

Geoff did it t a 1VJ here
http://www.tenere.co.uk/forum/viewtopic ... out#p12068
Is a 3MY stem the same as a 1VJ though?

jibber wrote:Geoff did it t a 1VJ here
http://www.tenere.co.uk/forum/viewtopic ... out#p12068
Is a 3MY stem the same as a 1VJ though?

He has also done it on one of his 3AJ`s as well.

Mezo.

Thanks for the replies lads. Front end swap is on then. What about the swingarm from the 750 would that swap over aswell.

The 750 uses a different linkage system where the shock passes through the swingarm so it is not a direct swap.

When I get chance I'll measure the width of my yolks so you can compare them to standard, you might not need new ones.

FYI. this looks like a 245mm front disk from a 750


The 660 has a 280mm as standard

Rick

xtzrick wrote:The 750 uses a different linkage system where the shock passes through the swingarm so it is not a direct swap.

When I get chance I'll measure the width of my yolks so you can compare them to standard, you might not need new ones.

FYI. this looks like a 245mm front disk from a 750


The 660 has a 280mm as standard

Rick

Hi mate thats a dt 125 wheel that i threw on to move the bike. That would be great if you could measure your yokes thanks

My yokes are 153mm between the stauntion tubes so 196mm center to center

Rick

xtzrick wrote:My yokes are 153mm between the stauntion tubes so 196mm center to center

Rick

Thank you mate