Mézo wrote:Very nice, have you thought about making pivot pegs?

Mezo.

I've never heard of them...
show me

http://www.pivotpegz.net/ http://www.youtube.com/watch?v=Wr6Ezzvpf7M

http://www.pivotpegz.net/img/Peg-Schematic.jpg

itchywheels wrote:http://www.pivotpegz.net/ http://www.youtube.com/watch?v=Wr6Ezzvpf7M

http://www.pivotpegz.net/img/Peg-Schematic.jpg

I DON'T LIKE IT. PIVOT PEGS
Footpegs must be stabile !!!

But I finally finished the Mark VII - I am very happy
Just make sample... not this week...

150 kg load on the tip, but the dark blue shows that the base is very tough

bosley1980 wrote:

itchywheels wrote:http://www.pivotpegz.net/ http://www.youtube.com/watch?v=Wr6Ezzvpf7M

http://www.pivotpegz.net/img/Peg-Schematic.jpg

I DON'T LIKE IT. PIVOT PEGS
Footpegs must be stabile !!!

Pivot Pegs are fucking awesome!

If they were $50, I'd have a couple of sets in a heartbeat.

NordieBoy wrote:

bosley1980 wrote:

itchywheels wrote:http://www.pivotpegz.net/ http://www.youtube.com/watch?v=Wr6Ezzvpf7M

http://www.pivotpegz.net/img/Peg-Schematic.jpg

I DON'T LIKE IT. PIVOT PEGS
Footpegs must be stabile !!!

Pivot Pegs are fucking awesome!

If they were $50, I'd have a couple of sets in a heartbeat.

OK if you like so buy it.
I DON'T PRODUCE PIVOT PEGS - you in wrong thread.

bosley1980 wrote:OK if you like so buy it.
I DON'T PRODUCE PIVOT PEGS - you in wrong thread.

Sod that, they cost a fortune!
We're waiting for you to start making them :)

This is looking down at my Bosley pegs

This was on a old timber bridge where u had to be very careful where u put your side stand

Technical drawing with dimensions and some small changes

Wide stainless steel foot pegs YAMAHA WR250R

...and of course implementation [Stainless Steel]






I hope that the customer will be satisfied.

Wide stainless steel foot pegs YAMAHA XT600E
here sketch

SIMULATION:
[youtube]BZTmKKyAem8[/youtube]
[youtube]cWaHg9Oqcdo[/youtube]
AND HERE FINAL PRODUCT



maybe I'll do some little changes

and some photo on the bike