Danjets Honda Transalp

[Danjet600]

Is that a spark plug?

M.

yep ripped the guts out and soldered in a valve so i can use the tire inflation gauge to check for leaking valves

[Danjet600]

I laced my own wheels but had 'em checked by a local wheel builder (Roy Thursby, amazing bloke still racing Ducati's at 70 odd... google him).... anyway he charges £10 per wheel to check them on his jig.... he would have done the whole job for £20 per wheel... can't remember how much I paid for the spokes.... will look for the bill..

that quote's at the cheaper end of the scale
i thinking i'll buy the spokes over the net and have a go myself

[Danjet600]

more wheel quotes

$155 per wheel for stainless spokes
$150 per wheel relace

seems to be the going rate in most of the shops around here
might just have a go at cleaning and painting the spokes and hubs see how they look

[Mezo]

Ive heard good reports about Ash`s Spoked Wheels but he`s not cheap by all accounts.

Mezo.

[Dirtybrit]

Get your spokes and have a go Dan.You could take one out at a time and replace it one by one. There are also some good vids on you tube, do your worst wheel first, for the price of a set of spokes you will have a good wheel. If you fuck up, it will only cost you another $150, and a lesson well learned. Take loads of pics though so myself and everyone else will know how to do it!

[Danjet600]

Get your spokes and have a go Dan.You could take one out at a time and replace it one by one. There are also some good vids on you tube, do your worst wheel first, for the price of a set of spokes you will have a good wheel. If you fuck up, it will only cost you another $150, and a lesson well learned. Take loads of pics though so myself and everyone else will know how to do it!

not a bad idea, take out few spokes so i can order the correct length ect, take lots of photo's of the spoke pattern, fuck it i'm game

while i'm waiting for the spokes i hopefully get this motor sorted out, got myself a USB powered endoscope and had a look in the motor can't see any valves staying open, nothing seems out of place i put the camera in and turned over the motor by hand watched the valves open close ect, i also pulled the plugs turned on the ignition and turn it over by hand to see when the spark plug fires, it looks like it fires before the inlet valves are shut, could the ignition timing be out of whack???
i've ordered a workshop manual
that may help

[Danjet600]

Ive heard good reports about Ash`s Spoked Wheels but he`s not cheap by all accounts.

Mezo.

$180 per wheel for spokes
$100 per wheel laced

[Danjet600]

it's ALIVE HA HA HA HAAAAAARR
read lots of forums and all basically came down to a fucked CDI, but when i swapped mine around it still started on rear cylinder and still had spark at all the spark plugs, it also said that the tacho won't work off a stuffed CDI, mine still worked, so i started to do continuity checks on all the wires running to the CDI's and found a dud wire
well i've checked the timing, cleaned and set the plug gaps and set the valve clearances, and i know the bike a bit better
i think i'm going to get some and have a to celebrate

[Dirtybrit]

Excellent! I will join you in a little celebration

[ActionManMelb]

Well done. Lucky you didn't pull the head/s off!!

I'll also join you in a celebratory drink.

Three pints ought to do it.